• Welcome To FranklinSports.com
  • $5 Ground Shipping On All Orders
[0]



Replacement Ball Holder Guide

Shown below is what you'll need

Step 1

You'll notice that there are three parts to your tee. What you need to measure is the top tube, so pull that out and put the rest aside.

Royal Enfield Motorcycle, photographed by Renjith Sasidharan

Step 2

You should have two sides (or ends) to your tube. One side where the ball sits on top (side A) and one where the tube inserts into the lower tube (side B). You need to work with side B.

Royal Enfield Motorcycle, photographed by Renjith Sasidharan

Step 3

Take your tape measure and measure either: The diameter from outside to outside of the tube or circumference.

Royal Enfield Motorcycle, photographed by Renjith Sasidharan

Measurements

If everything went well, you should have one of the following measurements. Simply match them up and check out the corresponding ball holders that are compatible with your set.

Diameter: 1 1⁄4" with Circumference: 4 3⁄8" (Wave Top - 1958Z3, 1957Z1) (Cup Top - 2776Z1)
Diameter: 1 1⁄2" Circumference: 4 7⁄8" (Cup Top - 2734Z1)